The method of resetting the password of the combination lock is as follows:
1. Use the initial password to open the password lock.
2. Rotate the combination lock 90° counterclockwise.
3. Press the lock ring down, and then the password part can be rotated.
4. Rotate the number, turn to the position of changing the password, and then pull up the lock ring to complete the setting.
5. Lock up the lock and use the new password to verify whether the setting is successful.
forget the password:
1. First, push the code towards the opposite direction where the switch can be pulled, then turn on the flashlight and shine it on the gap of the code lock; turn the code disk of the code lock, find the groove of the shaft while turning, and remember the groove The corresponding three numbers; add five to the number less than five, subtract five from the number greater than five, and the number obtained is the password of the combination lock.
2. Use your right hand to turn the password lock switch to the open direction with proper strength, slowly rotate from the leftmost digit, feel a slight movement of your right hand, and then come to the second digit, and then continue.
3. Start trial operation from 0001, it should not be able to open until 9999, one password per second, 1000 seconds can be rotated once, 20 minutes is enough! 2 seconds a password, 2000 seconds can be rounded, 35 minutes is enough!
How to reset coded brass padlock
1. Factory initialization: Press the touch button on the main board, after hearing the prompt "enter initialization", start initialization, and there will be a sound when the initialization is completed.
2. Enter the door opening password: press the "Add" button, after the prompt sound, "Enter the management password and end with #"; after entering the management password, enter the door opening password, and press the # button to confirm; re-enter the door opening password, press Confirm with the # key.
3. Enter the door-opening fingerprint: press the "Add" button, after the prompt sound, "Enter the management password, end with #"; after entering the management password, press the fingerprint, after the first entry is successful, it will prompt "Re-entry", and then press Once the fingerprint is registered successfully.